2 Default Gateway dalam satu sistem

Initial Position
We will assume that we have two interfaces: eth0 and eth1. The two networks that should be used are 192.168.0.0/24 and 10.10.0.0/24, whereby the first IP address in each respective network should be the gateway. Under Debian, the initial configuration would appear as follows. /etc/network/interfaces

# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
# The loopback network interface

auto lo
iface lo inet loopback

# The primary network interface

allow-hotplug eth0
iface eth0 inet static
    address 192.168.0.10
    netmask 255.255.255.0
    gateway 192.168.0.1

# The secondary network interface
allow-hotplug eth1
iface eth1 inet static
    address 10.10.0.10
    netmask 255.255.255.0

Adding a Second Routing Table

To add a new routing table, the file, /etc/iproute2/rt_tables must be edited. We will call the routing table “rt2” and set its preference to 1. The named file should then appear as follows.

#
# reserved values
#
255     local
254     main
253     default
0       unspec
#
# local
#
#1      inr.ruhep
1 rt2

Configuring the New Routing Table

From this point, four commands are needed to achieve our goal. First, the new routing table needs to be populated, which is done using the following command.

ip route add 10.10.0.0/24 dev eth1 src 10.10.0.10 table rt2
ip route add default via 10.10.0.1 dev eth1 table rt2

The first command says that the network, 10.10.0.0/24, can be reached through the eth1 interface. The second command sets the default gateway.

Routing Rules

So that the system knows when to use our new routing table, two rules must be configured.

ip rule add from 10.10.0.10/32 table rt2
ip rule add to 10.10.0.10/32 table rt2

These rules say that both traffic from the IP address, 10.10.0.10, as well as traffic directed to or through this IP address, should use the rt2 routing table.

Making the Configuration permanent

The ip rule and ip route commands will become invalid after a re-boot, for which reason they should become part of a script (for example, /etc/rc.local) that will be executed once the network has been started after booting. For Debian, these command can also be written directly into the /etc/network/interfaces file, which would then appear as follows.

iface eth1 inet static
    address 10.10.0.10
    netmask 255.255.255.0
    post-up ip route add 10.10.0.0/24 dev eth1 src 10.10.0.10 table rt2
    post-up ip route add default via 10.10.0.1 dev eth1 table rt2
    post-up ip rule add from 10.10.0.10/32 table rt2
    post-up ip rule add to 10.10.0.10/32 table rt2

More than Two Network Cards or Gateways

If there are more than two networks, a routing table can be created for each additional network analogous to the example presented above.

Testing the Configuration

The following commands can be used to ensure that the rules as well as the routing entries are working as expected.

ip route list table rt2
ip rule show